Electric Installation – operating the Electric to the Cabinet Print
This instructional guide will aid in the planning/installation associated with the Electrical Power provide for the Acrylic Spas.
Every one of our acrylic tubs have actually detachable case panels which cover the entire perimeter for https://hookupwebsites.org/alua-review/ the bath tub.
Whenever operating the electric through the spa, the access point in to the case doesn’t need become placed appropriate during the Control Pack location. Our spas try not to come loaded with a pre-drilled opening for electric so access may be through some of the case panels.*
*NOTE: We try not to advise setting up the electric via a case panel this is certainly situated in front side a Pump, Control Pack, Blower, or Gate Valve. These panels will need to be likely eliminated at some point for upkeep or servicing.
Selecting an area
Whenever choosing where you can go into the case, do this in line with the after:
- security (don’t create tripping hazards)
- looks
- access points for users to go into the bath bath tub
- action positioning
- cover opening position (bottom mount lifters could have the cover sleep low next to the cabinet)
- address lifter mounts
Creating an Access Aim
A Spade Bit is not recommended since there are no pre-drilled holes, access through the panel is done using a Hole Saw for a clean cut. The perfect location to put an opening for the cord, could be less than six ins up through the base associated with the case panel, and 3 to 4 ins in through the edge that is outside of case panel. Take note that the cabinet panels have actually lumber insulating and framework foam inserts. You will need to avoid drilling through the wood framework since this can damage the support that is structural lumber provides.
We usually do not suggest coming up through the beds base for the spa. If this is probably the most ideal path then we recommend you are taking under consideration you will never be able to slide the tub at all.
This might pose a nagging issue if a site professional is needed to access a part of this bath tub this is certainly against an obstruction such as for instance a wall surface or deck.
The Control Pack (where in actuality the electric will likely be linked) would be situated behind among the cabinet panels straight below your Topside Control Panel (precise location shall vary based on spa model).
There was space that is enough the case to operate the ability cord through the access point out the Control Pack even as we usually do not entirely fill the cavity with spray foam. The ability cord will need to go into the Control Pack through the hand side that is left.
To learn more about linking the electric to your circuit breaker, please click on our solution “Electrical Installation – Correct Wiring for a 240V Supply“.
In the event that you require any assistance that is further be sure to contact Customer provider.